Machine Tender/Metal Finisher (1st Shift)

Perform machine tending operations and processes; count, stage and record finished parts.  Remove burrs and sharp edges from manufactured parts using hand grinders, dynafiles, Burr Master and Tumbler.

• →Pull finished laser cut parts from the load tables and stack on carts.
• →Operate hand/air tools and electric grinders.
• →Verify part counts to the number of parts nested by the laser programmer.
• →Locate parts that have fallen to the ground through the table grates.
• →Accurately complete the Work Order paperwork.
• →Attach applicable part tags.
• →Move laser cut parts to the correct locations based on the next operation as dictated on the Job Travelers.
• →Empty the slag pans daily.
• →Clean the floor under the load table daily at specified time(s).
• →Complete daily 5S requirements.
• →Clean the lasers weekly.
• →Assist in other duties as requested by trainer, manager or supervisor.

• High school or general education degree (GED).  
• Machine shop experience is a plus.

• Read and interpret documents such as safety rules, operating and maintenance instructions, and procedure manuals. 
• Complete standardized written documentation and correspondence. 
• Professionally communicate in one-on-one and small group situations. 
• Ability to perform basic electronic tasks using computer software and Microsoft Office.

• Environment is a modern production facility with heat and air conditioning
• While performing the duties of this job, the employee is generally required to stand; use hands and fingers to manipulate raw materials, finished parts and cutting tools  
• Ability to twist at the waist 180 degrees (side to side) repetitively
• Ability to squat/bend and lift up to 15 pounds to place parts on machine at chest level repetitively
• Ability to lift 16 to 50 pounds occasionally
• Ability to squat and lift up to 75 pound fixtures to place on machine at chest level occasionally, with assistance
• Ability to reach over head with one arm to adjust setup dial regularly